AFEW IMPORTANT POINTS ABOUT ADBLUE

Adeblue’s physical and chemical properties

The shape of the adobe is crystal clear, clear. You will not smell a lot of Adblue, it has a high solubility in water and will freeze at -11 ° C. Not combustible and not explosive.

Adblue has a density of 1089 kg / m3 at 20 ° C. Adblue does not cause skin irritation or irritation, just wash the area soaked with soap and water.

Adblue reduces fuel consumption by up to 6% and offsets Adblue’s purchase cost.

Adblue maintenance instructions

The possibility of urea hydrolysis and the formation of ammonia and carbon dioxide at temperatures above 5 ° C is possible. A lower temperature than the crystallization temperature is not a good temperature to store. Avoid contact with any substances such as fuel, water, oil, dust, detergents with solution. Avoid exposing the adobe solution to light.

Note: (In case of freezing and formation of crystals, the solution can be slowly warmed and stirred and used. It should only be noted that there are no crystals in the solution that can cause clogging of the nozzle).

Gloves and goggles should be used if the adobe solution is in continuous contact. The use of metal and copper containers is prohibited because of corrosion. Do not mix Adblue with antifreeze and other solutions as this will damage the CSR and will no longer work.

The amount of phosphate, iron, copper, aldehyde and … water soluble in Adblue should be equal to or even lower than the reference standard. The life span of this solution is completely dependent on the storage conditions, however its approximate shelf life is approximately 6 months after production. Note that temperature was the most important factor in the life span of this solution.

Warning

Never disconnect the AdBlue system, the consequences of which are reduced engine power, dirty SCR pollution, reduced engine and exhaust life, and exit after-sales service.

Always carry the right amount of solution in the car. If the AdBlue tank is empty, do not start the engine because the engine will produce about half of its rated power.

What is SCR Technology?

It is based on the elimination of engine exhaust gases after fuel and air combustion, and will be the most cost-effective solution to meet Euro 2 and 3 environmental standards. To apply this technology, we need a solution called ” Adblue ” or ” AUS3 “. On the Catalyst System Gases react with ammonia in the vicinity of the catalyst, decomposing into water and nitrogen and leaving the exhaust. SC Technology R&D is currently being developed as an efficient and efficient technology and will be used in future cars. For the correct and effective operation of the SC system. The car has to make sure that only Adblue is dumped into the Adblue tank for purity and standard.